ICS Fab Toyota Tundra Dash Mount | '07 - '13 Tundra

ICS Fab Dash Mount – Toyota Tundra (2014–2021)

This dash mount is designed to accommodate AMPS standard attachments, allowing you to securely mount phones, tablets, dash cams, CBs, radios, and more. Perfectly tailored for your 2014–2021 Toyota Tundra, it offers a rugged, secure platform without the need for any drilling.

What’s Included:

• CNC laser-cut dash mount with fine black textured powder coat finish
• (5) M6 stainless steel hex socket cap screws
• (3) Stainless steel fender washers
• (2) Steel rectangular washers
• (5) M6 stainless steel nylon lock nuts
• Lifetime warranty against manufacturing defects and workmanship

⚠️ California Residents: WARNING: Cancer and Reproductive Harm
Optional dual QC 3.0 USB charger available.

Before You Buy:

• No drilling required
• Installation requires removal of the 12v socket trim, A/C controls, and radio
• If your truck has a center speaker, it must be removed or relocated underneath the dash if mount hardware interferes (we recommend 1/2” long screws)
• Factory center speakers are top-mounted and must be unbolted from above
• Buyer assumes all risk related to modification; ICS Fab is not liable for injury or damage due to improper installation

Tools Required:

• 5mm Allen wrench
• 10mm socket
• Long extension
• Ratchet
• Trim removal tools

Installation Steps:

1. Use trim tools to remove the center dashboard speaker cover.
2. Pre-install your mounts (e.g., RAM) on the dash mount in your preferred layout.
3. Insert the five provided screws into the dash mount and rest the mount on the dash to confirm fitment—ensure mount hardware does not interfere with dash structure.
4. Remove the lower 12v tray (no need to unplug—just lay it down).
5. Carefully remove trim around the A/C fan speed knob and remove the A/C controls. Again, just lay them down.
6. Remove the four 10mm bolts holding the radio, disconnect the antenna cable, and lay the radio aside.
7. Insert the dash mount and screws into position.
8. On the three front screws, install fender washers and lock nuts.
9. On the two rear screws, install the rectangular washers and lock nuts.
10. Tighten screws hand-tight, then an additional 1/4 turn. Do not over-tighten.
11. Reinstall the radio and all removed trim pieces.

Note:
We recommend having your mounting hardware (e.g., RAM ball mounts) ready and pre-installed on the dash mount before installation.