Tundra JBL Amp Bypass Harness | 2014-2021 Tundra

Tundra JBL Amp Bypass Harness | 2014-2021 Tundra

Here is a simple and easy breakdown of how to install you new
JBL Amplifier Bypass Plug & Play Harness from Trail Grid Pro!

Step 1

Gaining access to the factory JBL amplifier:

  • Removing the front passenger seat:
    • Remove two 14 mm bolts holding the passenger front seat bracket in place.
    • Slide seat forward to access the rear seat bolts.
    • Gently lift up while pulling back on trim to remove the two plastic trim pieces covering the rear 14 mm bolts.
    • Remove the two 14 mm bolts.
    • Slide seat back, lift up and lean back to give access under seat or unplug up to three plugs and remove seat from vehicle.

Step 2

Remove the factory JBL amplifier:

  • Remove the three black plastic hold down pins using a panel tool.
  • Remove black plastic cover over amplifier.
  • Remove all three plugs located on the side of the amplifier.
  • Lift the carpet flap to expose the amplifier mounting bracket.
  • Remove the three 10 mm bolts holding amplifier to vehicle and remove from the vehicle.

Step 3

Connecting the Trail Grid Pro JBL Bypass Harness:

  • The bypass harness has two plugs:
    • One 10 pin connector.
    • One 12 pin connector.
  • Match the appropriate connectors to the factory plugs and connect.

Step 4

Connecting the JBL Bypass Harness to your amplifier:

  • Rear Left + Green
  • Rear Left - Green/Black Stripe
  • Rear Right + Purple
  • Rear Right - Purple/Black Stripe
  • Front Left + White
  • Front Left - White/Black Stripe
  • Front Right + Grey
  • Front Right - Grey/Black Stripe
  • SUB – Black
  • SUB + Red
Back to blog