This is NOT a spacer lift, this kit retains your factory ride quality, factory suspension geometry, you can still align it to factory specs and does not effect your suspension travel. After install your truck or SUV will sit level front to rear.
This kit includes everything you will need, No replacement Upper Control Arm (UCA) needed.
You can run up to a 35” tire without a body mount chop (BMC).
This kit provides the following lifts:
-
Tacoma TRD Pro (2024): 1.75” (front lift) 0.75″ (rear lift)
SAEJ2492 Warning: By installing this product, you acknowledge that the suspension of this vehicle has been modified. As a result, this vehicle may handle differently than that of factory-equipped vehicles. As with any vehicle, extreme care must be used to prevent loss of control or roll-over during sharp turns or abrupt maneuvers. Always wear seat belts, and drive safely, recognizing that reduced speeds and specialized driving techniques may be required. Failure to drive this vehicle safely may result in serious injury or death. Do not drive this vehicle unless you are familiar with its unique handling characteristics and are confident of your ability to maintain control under all driving conditions. Some modifications (and combinations of modifications) are not recommended and may not be permitted in your state. Consult your owner’s manual, the instructions accompanying this product, and state laws before undertaking these modifications. You are responsible for the legality and safety of the vehicle you modify using these components.